Safety Instructions; Electrical Connection - Electrolux EHL9530FOK Manual De Instrucciones

4 www.electrolux.com
Do not store items on the cooking surfaces.
•
Metallic objects such as knives, forks, spoons and lids
•
should not be placed on the hob surface since they
can get hot.
Do not use a steam cleaner to clean the appliance.
•
After use, switch off the hob element by its control and
•
do not rely on the pan detector.
If the glass ceramic surface / glass surface is cracked,
•
switch off the appliance to avoid the possibility of
electric shock.
If the supply cord is damaged, it must be replaced by
•
the manufacturer, an authorized Service or similarly
qualified persons in order to avoid a hazard.

2. SAFETY INSTRUCTIONS

2.1 Installation
WARNING!
Only a qualified person must
install this appliance.
• Remove all the packaging.
• Do not install or use a damaged
appliance.
• Obey the installation instruction
supplied with the appliance.
• Keep the minimum distance from the
other appliances and units.
• Always be careful when you move the
appliance because it is heavy. Always
wear safety gloves.
• Seal the cut surfaces with a sealant to
prevent moisture to cause swelling.
• Protect the bottom of the appliance
from steam and moisture.
• Do not install the appliance adjacent
to a door or under a window. This
prevents hot cookware to fall from the
appliance when the door or the
window is opened.
• If the appliance is installed above
drawers make sure that the space,
between the bottom of the appliance
and the upper drawer, is sufficient for
air circulation.
• The bottom of the appliance can get
hot. Make sure to install a non-
combustile separation panel under the
appliance to prevent access to the
bottom.
• Make sure that the ventilation space
of 2 mm, between the worktop and
the front of the below unit, is free. The
warranty does not cover damages
caused by the lack of an adequate
ventilation space.

2.2 Electrical Connection

WARNING!
Risk of fire and electrical
shock.
• All electrical connections should be
made by a qualified electrician.
• The appliance must be earthed.
• Before carrying out any operation
make sure that the appliance is
disconnected from the power supply.
• Make sure that the electrical
information on the rating plate agrees
with the power supply. If not, contact
an electrician.
• Make sure the appliance is installed
correctly. Loose and incorrect
electricity mains cable or plug (if
applicable) can make the terminal
become too hot.
• Use the correct electricity mains
cable.