Magic Chef MCSRE24S Manual Del Usuario página 15

NOTE: DO NOT install the power cord without a strain relief. The strain relief bracket MUST be installed before
reinstalling the rear range wiring cover.
3- Wire
Installation (Ground is through the neutral wire)
1. Remove the 3 lower screws from the terminal
block. DO NOT cut or remove the ground
strap.
2. Insert the 3 screws through each power cord
terminal ring and back into the terminal block.
be certain the white/neutral wire is in the
center. Securely tighten each screw (35 to 50
in-lbs.).
3. Replace wire cover on range back by sliding its
left edge under the retaining tabs and replace
the screws removed earlier. Make sure that no
wires are pinched between cover and range
back. (Refer to Figure 12.)
4-Wire Installation (Separate ground wire)
1. Remove the 3 lower screws from the terminal
block. Remove the ground screw and ground
plate and retain them.
2. Cut the ground strap below the terminal block
and discard the lower section.
3. Insert the ground screw through the ground
plate (removed earlier) and back into the range
frame. Tighten securely, but do not over-
tighten (15 to 20 in-lbs.)
4. Insert the 3 terminal screws through each
power cord terminal ring and back into the
terminal block. be certain the white/neutral
wire is in the center. Securely tighten each
screw (35 to 50 in-lbs.).
5. Replace wire cover on range back by sliding its
left edge under the retaining tabs and replace
the screws removed earlier. Make sure that no
wires are pinched between cover and range
back. (Refer to Figure 13.)
Terminal block
(appearance may vary)
Red Wire
White/
Neutral
Wire
Terminal block
(appearance may vary)
Red Wire
White/
Neutral
Wire
Ground Screw Green Wire
15
Figure 12
Ground
Strap
black Wire
bracket
Figure 13
Ground
Strap
black Wire
bracket