Vacuum Fans; Dust FI Lters; Cleaning The Dust FI Lters; Dust Flaps - RCM BOXER Serie Manual De Uso Y Mantenimiento

The vacuum fans are used to suck in the dust raised by the brushes.
When the motor sweeper is in operation, the fans must always be running, except for the following cases, when
they must stop:
- water present on the ground to be swept
- when the refuse hopper is tipped up
- when the dust fi lters are vibrated (when switch 14 fi g. 1 is operated to vibrate the fi lters, the fans stop au-
tomatically).
1. vacuum fan/s
2. (standard) sacks dust vacuum fi lter
3. (optional) cartridges dust vacuum fi lter
4. rear cover for inspection sacks dust fi lter
5. cleaning kit for sack dust fi lter
6. upper cover
DUST FILTERS
The dust fi lters remove the dust from the air sucked up by the suction fans. They must be kept in peak condition.
CLEANING THE DUST FILTERS
- Stop the fans by turning the switch 14 (Fig. 1) to the central position.
- Turn switch 14 (Fig.1) to position B to vibrate the fi lters for about 5 sec.
- Repeat 4-5 times in succession.
WARNING!
Do not keep the switch pressed constantly as this may damage the electrical system.
If the machine is working in a very dusty environment the fi lter 2 must be cleaned frequently.
Removing rear cover and clean fi lter by a vacuum cleaner and its cleaning kit.
To allow the fi lters to be cleaned more thoroughly, they must be removed:
- remove the fi lter upper cover.
- remove the fi lter and clean it thoroughly with a compressed air jet or preferably with a vacuum cleaner, starting from
the inside of the sacks where the dust collects most.
- never use metal or wooden tools for cleaning.
- disconnect the fi lter shaker cable.
- when fi tting the new fi lter, make sure that the cover seal is airtight and that the fi lter is properly positioned.
- reconnect the fi lter shaker.
- replace the fi lter cover.
DANGER!
Protect eyes and hair when cleaning with compressed air guns, always use a breathing safety mask.
The dust fl aps prevent the dust raised by the brushes from blowing out from under the motor sweeper. They
must therefore be kept in peak condition and replaced if they become worn or damaged.
REPLACING THE FLAPS
- remove the fi xing bolts and remove the worn or damaged fl ap.
- fi t a new fl ap and secure it in position with the same bolts. The side and rear fl aps should ride at about 4 - 5 mm above
fl oor level.

VACUUM FANS

(FIG.17)

DUST FLAPS

ENGLISH
53