Troubleshooting - FSP FP 400 Manual De Instrucciones

5. Trouble Shooting
Use the table below to solve minor problems.
Problem
No LED display on the
front panel.
Alarm continuously
sounds when the
mains is normal.
When power fails,
back-up time is
shorten.
The mains is normal
but LED is flashing.
6. Specifications
Model
CAPACITY
INPUT
Voltage
Voltage Range
OUTPUT
Voltage Regulation
Transfer Time
Waveform
BATTERY
Type & Number
Charging Time
PHYSICAL
Dimension (DxWxH)
Net Weight (kgs)
Environment
Humidity
Noise Level
Possible Cause
Low battery.
Battery fault.
The UPS is not turned on.
The UPS is overloaded.
The UPS is overloaded.
Battery voltage is too low.
Battery defect. It might be
due to high temperature
operation environment, or
improper operation to battery.
Power cord is loose.
FP 400
400 VA / 240 W
12 V/4.5 AH x 1
4-6 hours recover to 90% capacity
3.55
0-90 % RH @ 0-40° C (non-condensing)
Charge the UPS at least 6 hours.
Replace the battery with the same
type of battery.
Press the power switch again to turn
on the UPS.
Remove some loads first. Before
reconnecting equipment, please
verify that the load matches the UPS
capability specified in the specs.
Remove some critical load.
Charge the UPS at least 6 hours.
Replace the battery with the same
type of battery.
Reconnect the power cord securely.
FP 600
600 VA / 360 W
220/230/240 VAC
162-290 VAC
+/-10%
Typical 2-6 ms
Simulated Sine Wave
12 V/7 AH x 1
279 x 101 x 142 mm
4.2
Less than 40 dB
4
Solutions
FP 800
800 VA /480 W
12 V/9 AH x 1
4.9