Weber Genesis E-310 Guia Del Propietario página 10

Ocultar thumbs Ver también para Genesis E-310:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

10
To Connect the hose to the cylinder:
1)
Pass the regulator hose through the side panel opening to the inside of the base
cabinet.
2)
Locate hose retention clip (a) on regulator hose. Secure into slot (b) on underside
of tank scale.
WARNING: The hose must be secured to the tank scale
with the Hose Retention Clip. Failure to do so could cause
damage to the hose resulting in a fi re or explosion which
can cause serious bodily injury or death, and damage to
property.
The LP cylinder is installed inside the base cabinet, on the tank scale (right side).
3)
Open base cabinet doors.
4)
Turn the LP cylinder so the opening of the valve is either to the front, side or rear
®
of the Weber
gas barbecue. Lift and hook the cylinder onto the fuel gauge.
5)
Lift tank up into position on the tank scale.
6)
Loosen the cylinder lock wing nut. Swing the cylinder lock down.
Tighten the wing nut.
Some LP tanks have differing top collar assembles. (The top collar is the metal
protective ring around the valve.) One series of tanks mount with the valve facing front
(a). The other tanks mount with the valve facing away from the fuel scale (b). Weber
recommends the use of cylinder manufacturer's Manchester and Worthington, with a
47.6 lb water capacity. Other cylinders may be acceptable for use with the appliance
provided they are compatible with the appliance retention means (see illustrations).
7)
Remove the plastic dust cover from the valve.
8)
Screw the regulator coupling onto the tank valve, clockwise, or to the right.
Hand-tighten only.
Note: This is a new type of connection. It tightens clockwise and will not allow gas to
fl ow unless the connection is tight. The connection requires tightening by hand only.
WARNING: Do not use a wrench to tighten the connection.
Using a wrench could damage the regulator coupling and
could cause a leak.
You will need: LP cylinder, a soap and water solution and a rag or brush to apply it.
9)
Mix soap and water.
10)
Turn on the cylinder valve.
11)
Check for leaks by wetting the fi tting with the soap and water solution and
watching for bubbles. If bubbles form, or if a bubble grows, there is a leak.
If there is a leak, turn off the gas and tighten the fi tting. Turn the gas back on and
recheck with the soap and water solution.
If leak does not stop, contact the Customer Service Representative in your area using
the contact information on our web site. Log onto www.weber.com
barbecue.
12)
When leak checking is complete, turn gas supply OFF at the source and rinse
connections with water.
GAS INSTRUCTIONS
GAS INSTRUCTIONS
®
. Do not use the
WWW.WEBER.COM
®

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Genesis s-310Genesis e-320Genesis s-320Ep-310Ep-320Genesis ep-310 ... Mostrar todo

Tabla de contenido