GYS GYSMI 80P Manual De Instrucciones página 7

MADE IN FRANCE
WARNING - SAFETY RULES
GENERAL INSTRUCTIONS
Read and understand the following safety recommendations before using or servicing the unit.
Any change or servicing that is not specified in the instruction manual must not be undertaken.
The manufacturer is not liable for any injury or damage due to non-compliance with the instructions featured in this
manual .
In the event of problems or uncertainty, please consult a qualified person to handle the inspection properly.
ENVIRONMENT
This equipment must only be used for welding operations in accordance with the limits indicated on the descriptive panel
and/or in the user manual. The operator must respect the safety precautions that apply to this type of welding. In cases
of inedaquate or unsafe use, the manufacturer cannot be held liable.
This equipment must be used and stored in a place protected from dust, acid or any other corrosive agent. Operate the
machine in an open, or well-ventilated area.
Operating temperature:
Use between -10 and +40°C (+14 and +104°F).
Store between -25 and +55°C (-13 and 131°F).
Air humidity:
Lower or equal to 50% at 40°C (104°F).
Lower or equal to 90% at 20°C (68°F).
Up to 2000 meters above sea level (6500 feet).
INDIVIDUAL PROTECTIONS AND OTHERS
Welding exposes the user to dangerous heat, arc rays, electromagnetic fields, noise, gas fumes, and electrical shocks.
People wearing pacemakers are advised to consult with their doctor before using this device.
In order to protect you from burns and radiation, wear clothing with long sleeves. These clothes must be
insulated, dry, fireproof and in good condition, and cover the whole body.
Wear protective gloves which guarantee electrical and thermal insulation.
It may be necessary to install fireproof welding curtains to protect others against arc rays, weld spatter
and sparks.
Inform the people around the working area to never look at the arc ray or the molten metal, and to wear
protective clothes.
It is necessary to protect yourself with a welding hood (rated NR.10 or higher) and to protect your eyes
during cleaning operations.
Do not operate whilst wearing contact lenses.
Ensure ear protection is worn by the operator if the work exceeds the authorised noise limit. Ensure ear
protection is worn by anyone in the welding area .
Keep hands, hair, clothes etc... away from moving parts (e.g. fan)
Never remove the safety cover of the wire feeder when the machine is plugged in - The manufacturer is
not responsible for any accident or injury that happens as a result of not following these safety precau-
tions.
The pieces that have just been welded are hot and may cause burns when touched.
During maintenance work on the torch or electrode holder, you should make sure it's cold enough and
wait at least 10 minutes before any intervention. ALWAYS ensure the working area is left as safe and
secure as possible to prevent damage or accidents.
WELDING FUMES AND GAS
The fumes, gases and dust produced during welding are hazardous. It is mandatory to ensure adequate
ventilation and/or extraction to keep fumes and gases away from the work area. An air fed helmet is
recommended in cases of insufficient air supply in the workplace.
Check that the air intake is in compliance with safety standards
GYSMI 80P 130P 160P 200P
EN
7