Low Battery Indication: An illuminated Yellow LED indicates an abnormally low battery condition.
This may be due to low battery voltage or a missing battery. When this happens the Red warning
LED will flash, the audible beep will sound, and the remote indicator will be enabled. When the user
is alerted to the warning status, the illuminated condition of the Yellow LED and the lighted condition
of all the Green module LEDs denotes a battery fault and not a TVSS module power or fuse fault.
The Disable Battery switch should then be pressed to silence the audible alarm beep, flashing
LED, and remote warning for the battery malfunction. The Yellow LED may remain illuminated as a
reminder that the battery needs replacing. This action re-enables the warning function to continue to
monitor TVSS faults. When the battery is replaced, the Disable Battery switch should be momentarily
pressed. A fresh battery, when the disable battery switch is pressed, will cause the Yellow LED to turn
OFF and will re-enable the Low Battery warning function after pressing the battery disable switch.
Battery Replacement: Press battery holder and slide battery out. Be sure to follow the battery
polarity marking on the battery compartment.
Test Switch: A "Press to Test Switch" enables the user to test for proper operation of all the functions
described above. When the test switch is held down, the following functions will occur:
• The Yellow low battery LED will illuminate.
• The Red warning LED will flash.
• The audible tone beeper will sound.
• The Remote Supervisor Panel warning indicator (an accessory item), if wired in, will be activated,
thus also testing the Remote Supervisor Panel.
Table 1 - Diagnostic Indicator Functions:
List of the diagnostic functions of the 52000
series panels.
Mode
Fault
Beeper
LED
(Red)
Normal
OFF
OFF
OFF
OFF
Module
ON
ON
Fault
ON
OFF
Low
ON
ON
Battery
OFF
OFF
No AC
ON
ON
Power
ON
OFF
OFF
OFF
Self
ON
ON
Test
Page 8
Remote Module
Battery
LEDs
Status
(Green)
LED
(Yellow)
OFF
ON
OFF
OFF
ON
OFF
one or more
ON
OFF
ON
OFF
OFF
ON
ON
ON
OFF
ON
ON
ON
OFF
OFF
ON
OFF
OFF
ON
OFF
OFF
ON
ON
ON
Beeper
Battery Disable
("Low Battery")
("Audio Alarm")
Disable Disable Disable Disable
Button
LED
Button
OUT
OFF
OUT
IN
ON
OUT
OUT
OFF
OUT
IN
ON
OUT
OUT
OFF
OUT
OUT
OFF
IN
OUT
OFF
OUT
IN
OFF
OUT
OUT
OFF
IN
OUT
OFF
OUT
Self Test
("Test")
Momentary
LED
Action
Button
OFF
OUT
OFF
OUT
OFF
OUT
OFF
OUT
OFF
OUT
ON
OUT
OFF
OUT
OFF
OUT
OFF
OUT
OFF
IN