Leviton 52000 Serie Instrucciones De Instalación página 8

L1
L2
L3
N
G
Circuit Breaker Panel
Wye system illustrated —
Delta system would not include neutral line
L1
L2
L3
N
G
Circuit Breaker Panel
Wye system illustrated —
Delta system would not include neutral line
10. Activate the system by turning AC power ON: The Green Module Status lights should be
illuminated and visible through the ports in the enclosure door, and all other lights should be OFF. If
problems are encountered that can not be resolved using the Problem Isolation Procedure printed
on the inside of the enclosure door, contact Leviton Technical Support: 1-800-648-3332.
11. Diagnostic Test: Press and hold down the test button. The Red warning indicator should blink,
the audible tone signal should beep, the Yellow low battery light should illuminate, and the Remote
Supervisor Panel warning indicator, if wired in, will be activated. Release the test button.
Page 6
Fig. 7 – TVSS Feed Through Connection
Fig. 8 – TVSS Shunt Connection
Conduit
G N L1 L2 L3
TVSS
Conduit
Connection Enclosure
G N L1 L2 L3
TVSS
To
loads
up to
100
Amps
N
G
TVSS
will accept
up to
#3 AWG
stranded
wire
To
loads
N
G
30 Amp
Disconnect
Switch