Description; Features; To Install; English - Leviton 52000 Serie Instrucciones De Instalación

Para paneles de distribución de circuitos principales o derivados
Ocultar thumbs Ver también para 52000 Serie:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

The 52000 TVSS Panel Protection System is a high-performance Transient Voltage Surge
Suppressor designed for use on main distribution and branch circuit panels.
• Replaceable plug-in modules, which facilitate maintenance.
• Hybrid component suppression design.
• TVSS protection on all phases.
• Common Mode TVSS protection for WYE Systems.
• Diagnostic monitoring of each phase module.
• Acoustic as well as visual failure indicators.
• Provisions for operation with an optional Remote Supervisor Panel, allowing monitoring of TVSS
status from distant locations.
• UL Listed (except 52347-M3) and CSA Certified design.
• 48-62 Hz operation.
• Location per IEC std: Class III.
• One port.
• Optional surge counter with front panel LCD display.
WARNING:
TO BE INSTALLED AND/OR USED IN ACCORDANCE WITH APPROPRIATE
ELECTRICAL CODES AND REGULATIONS (INCLUDING NEC/CEC, AS APPLICABLE).
WARNING:
IF YOU ARE NOT SURE ABOUT ANY PART OF THESE INSTRUCTIONS, CONSULT A
QUALIFIED ELECTRICIAN.
WARNING:
TO AVOID FIRE, SHOCK, OR DEATH; TURN OFF POWER AT CIRCUIT BREAKER
OR FUSE AND TEST THAT THE POWER IS OFF BEFORE WIRING!
WARNING:
THIS DEVICE IS NOT A LIGHTNING ARRESTOR. IT WILL NOT SURVIVE LIGHTNING
STRIKES IN CLOSE PROXIMITY TO THE PREMISES OR SUSTAINED OVERVOLTAGES.
WARNING:
ELECTROCUTION AND FATAL OR SERIOUS INJURY AND PROPERTY DAMAGE
CAN RESULT FROM FAULTY INSTALLATION.
CAUTION:
USE THIS DEVICE ONLY WITH COPPER OR COPPER CLAD WIRE. WITH
ALUMINUM WIRE USE ONLY DEVICES MARKED CO/ALR OR CU/AL.
NOTE:
DO NOT OPERATE AT ALTITUDES EXCEEDING 2000 METERS.
NOTE:
OPERATE INDOORS BETWEEN 30-90% RELATIVE HUMIDITY.
NOTE:
IT IS RECOMMENDED THAT THE 52000 TVSS PANEL PROTECTION SYSTEM BE
INSTALLED BY A QUALIFIED ELECTRICIAN.
1. Identify the device or load to be protected: The 52000 Panel should be located as close as
possible to the electrical panel serving the load to be protected in order to minimize connection lead
length resistance and inductance.

DESCRIPTION

FEATURES

TO INSTALL

Page 1

Publicidad

Capítulos

Tabla de contenido
loading

Tabla de contenido