CASO DESIGN FastVac 500 Operación Manual página 41

11 Vacuum chamber: Position the open end of the bag inside the chamber.
12 Sealing profile: Presses the bag tightly onto the sealing bar (17).
13 Lower gasket + 14 Upper gasket
15 Cutter: To cut the bags.
16. Air intake: Air intake connects with vacuum chamber and pump. Do not cover this air
intake when placing bag for Vacuum&Seal operations.
17 Sealing bar:
seal but not to stick to the strip. Place the bag over this sealing element.
Warning
The sealing bar gets very hot.
Please observe the following safety notice in order not to burn yourself or others.
► To avoid getting burned, never touch the sealing bar directly after sealing process.
► Do not remove the Teflon tape (T).
Contains a heating wire covered with teflon which allows the bag to
Please note
41