Automatic Station Search And Store - Loewe DVB-T Instrucciones De Manejo

Initial start-up

Automatic station search and store

This function is of particular advantage if you are only searching for new
stations.
1. Switch on your TV and
if no menu is displayed, call the "TV-menu" by pressing the MENU
button on the remote control
2. Select the "Settings" item and confirm with OK.
Note:
If you use an active terrestrial antenna, this requires a supply voltage
(5 Volt). In this case, select the „Connections - Antenna DVB - Antenna
DVB-T" line in the „TV menu". Press the OK button and then select
„Yes (5 V)". Confirm with OK.
3. Select "Connections", then " Settings–Channels" and confirm with
OK.
4. Select "Automatic search" and confirm with OK.
You will get a table for the automatic programme search.
5. Select "Change search settings" and confirm with OK. Follow the
menus.
Change search settings
Select channel source
Antenna/cable (analogue)
Antenna DVB-T
Satellite 1: ASTRA1 (DVB-S)
Antenne DVB
Proceed
OK
6. Indicate whether you are searching via antenna/cable (analogue),
antenna DVB-T or in the satellite range (DVB-S).
In DVB-T you can select a channel search (fast station search) or a
frequency search.
7. Indicate whether you wish to have all stations or only new ones
searched for.
8
DVB_T_S_GB_F_Esp
OK
END
Back
#
8
Notes:
• The frequency search option is to be preferred only in exceptional
cases such as in the event of deviations from the standardized
channels.
• If you have purchased a CI module, please insert it before you start the
search because only then will the provider's coded programs be
recognized and stored.
• If you change the CI module, you have to run a new station search so
that the stations of the new provider can be found and stored.
• Which of the programs of the provider you can watch in the end
depends on which program package you have bought.
• To extend an existing station list we recommend you to activate the
option search and store "new stations only".
8. Confirm your selection with OK.
9. Specify from which program place the stations are to be stored and
confirm with OK.
10. Select the "Run search" line and confirm with OK.
The station search may take some time.
Do not make any entries or switch off the set during this time.
When the search has ended you will be shown the found and stored
stations sorted in numerical order.
If you also want to search for and store analog programs, press the MENU
button. Repeat the steps 5 to 10.
Select "Analog" in step 6 and the transmission standard, e.g. "Autom.–
BG".
After the station search has been completed, hide the table by pressing
the END button.
18.11.2004, 13:51 Uhr