Adjusting The Kick Panel - Thermador Professional PRO HARMONY PRG30 Manual De Instalación

Griddle Tilt Adjustment
If the range is equipped with an electric griddle, check the
griddle frame adjustment by pouring two tablespoons of
water on the back of the griddle plate. The water should
slowly roll into the grease tray. If not, adjust the two screws
under the back of the frame. Start with one half turn
counterclockwise (CCW) of the screws. Further adjustment
should be made by one-quarter turn until water slowly flows
into the grease tray.
Leveling Screws
Figure 24: Griddle Leveling Screws
WARNING:
To avoid risk of injury, never operate the griddle without
the griddle plate installed. Never use griddle in a manner
that is not prescribed by the Use and Care Manual.
The griddle plate must always be in place when the
griddle is turned on.
(not all models)

Adjusting the Kick Panel

To adjust the kick panel do the following:
1. Remove the kick panel screws using a T-20 Torx
screwdriver.
2. Slightly push panel up then out to clear aluminum cast
base tabs.
3. Relocate kick panel at one of the five screw hole
positions, as noted in Figure 25. Reinstall Torx screw.
4. Repeat on the opposite side, assuring kick panel is
level.
• The range kick panel should maintain a minimum
½" (12.7mm) clearance above the floor.
Kick Panel
Adjustment Holes
Figure 25: Kick Panel Adjustment
English 25