Preset Tare (Not Available On Approved Scales) - Adam Equipment GBK Serie Manual De Instrucciones

EN
added to the first one. Again only the weight that is added after taring
will be displayed.
NOTE:
When the container is removed a negative value will be shown. If the scale was
tared just before removing the container, this value is the gross weight of the
container plus all products which were removed. The zero indicator will also be on
as the platform is back to the same condition it was when [Zero] was pressed last.
Press [Tare] or [Zero] to remove the tare value and display zero. The Net indicator
will disappear.
10.2.2

PRESET TARE (NOT AVAILABLE ON APPROVED SCALES)

When the scale is at zero with no weight on the platform it is possible to enter a
preset tare.
• Zero the scale by pressing [Zero]. The zero indicator will be on.
• Enter a value using the numeric keys.
• Press [Tare] to tare the scale. The value that was entered is stored as
the tare value and it is subtracted from the display, leaving a negative
number on the display.
© Adam Equipment Company 2011 17 3056610542RevD-Aug11