Setting Power-Saving Mode / Standby Time; Cleaning And Maintenance - Bellarom BKM 1250 A1 Instrucciones De Uso

Setting power-saving mode / standby time

You can set the time required for the appliance to switch off automatically to
either 15 minutes or 30 minutes without pressing a button .
The appliance is switched off and the lever 1 is pressed down .
1) Press and hold the Espresso
quent flashing indicates which standby time is set .
–
Espresso
–
Espresso
30 minutes is set .
2) Press the Espresso button
standby times .
3) Once the desired standby time is set, press and hold the Lungo
button until both buttons flash so as to quit setting mode .
The appliance starts to heat up .

Cleaning and maintenance

DANGER – RISK OF ELECTRIC SHOCK!
► Before cleaning the appliance, disconnect the power plug from the mains
power socket! Otherwise there is the risk of electric shock!
► Never open any parts of the housing . There are no serviceable parts
whatsoever inside . When the housing is open, there is the risk of receiving
a potentially fatal electrical shock . This does not apply to the capsule
compartment .
Never immerse the appliance in water or any other liquid! There is a
risk of fatal electric shock if residual liquids come into contact with live
components during operation .
WARNING – RISK OF INJURY!
► Allow the appliance to cool sufficiently before cleaning it . Risk of burns!
CAUTION – PROPERTY DAMAGE!
► Do not use abrasive or caustic cleaning agents . These can attack the
surface and damage the appliance beyond repair .
■ Pull the capsule container 6 together with the drip tray 9 out of the appliance .
Then pull the capsule container 6 carefully forwards off the drip tray 9 .
Empty the capsule container 6 and drip tray 9 .
BKM 1250 A1
2 button for approx . 3 seconds . Its conse-
2 button flashes once = Standby time of 15 minutes is set .
2 button flashes twice in succession = Standby time of
2 once in order to change between the two
4
29 ■
GB│IE │