Removing The Blower Tube; Removing The Battery From The Blower; Charging The Battery Pack - Toro Flex-Force Power System Manual De Instrucciones

Removing the Blower Tube

Press down on the tab latch to separate the blower
tube from the blower (Figure
1. Tube latch
Removing the Battery from
the Blower
Press the battery latch to release the battery pack and
slide the battery pack out of the blower
1. Battery latch

Charging the Battery Pack

Important:
The battery pack is not fully charged
when you purchase it. Before using the tool for
the first time, place the battery pack in the charger
and charge it until the LED display indicates the
battery pack is fully charged. Read all safety
precautions.
Important:
Charge the battery pack only in
temperatures that are within the appropriate
range; refer to Specifications (page
Note:
At any time, press the battery-charge-indicator
button on the battery pack to display the current
charge (LED indicators).
1. Make sure that the vents on the battery and
battery charger are clear of any dust and debris.
4).
Figure 4
(Figure
Figure 5
5).
g273159
1. Battery pack cavity
2. Battery pack venting areas 6. Handle
3. Battery pack terminals
4. Battery-charge-indicator
5).
button
2. Line up the cavity in the battery pack
with the tongue on the charger.
3. Slide the battery pack into the charger until it is
fully seated
4. To remove the battery pack, slide the battery
backward out of the charger.
5. Refer to the following table to interpret the LED
indicator light on the battery charger.
g267488
Indicator Indicates
light
Off No battery pack inserted
Green Battery pack is charging
blinking
Green Battery pack is charged
Red Battery pack and/or battery charger is over or under
the appropriate temperature range
Red
Battery pack charging fault*
blinking
*Refer to Troubleshooting (page 9)
information.
7
Figure 6
5. LED indicators (current
charge)
7. Charger LED indicator
light
8. Charger venting areas
(Figure 6).
for more
g290533
(Figure 6)