Loose Parts; Mounting The Battery Charger (Optional); Assembling The Blower - Toro Flex-Force Power System 51820 Manual Del Usuario

Setup

Loose Parts

Use the chart below to verify that all parts have been shipped.
Description
Mounting hardware (not included)
Blower tube
Note:
The battery pack is not fully charged when you
purchase it. Before using the tool for the first time,
refer to Charging the Battery Pack (page
Mounting the Battery
Charger (Optional)
If desired, mount the battery charger securely on a
wall using the wall-mount key holes on the back of
the charger.
Mount it indoors (such as a garage or other dry place),
near a power outlet, and out of the reach of children.
Refer to Figure 1 for assistance in mounting the
charger.
Slide the charger over the appropriately positioned
hardware to secure the charger in place (hardware
not included).
8).
Figure 1
Qty.
2 Mount the battery charger (optional).
1 Assemble the blower.

Assembling the Blower

1. Slide the blower tube onto the blower housing.
You may need to press down on the tube latch
for the blower tube to lock into place
1. Tube latch
2. Align the cavity on the battery pack with the
tongue in the handle housing, grasp the handle,
and push the battery pack into the handle until
the latch locks into place
1. Battery latch
g247359
6
Use
(Figure
Figure 2
(Figure 3).
Figure 3
2).
g273147
g273146