Preparing To Use Your Phone; Preparing To Use The Handset; Inserting The Batteries - Siemens Gigaset C1 Manual Del Usuario

Preparing to use your phone

Preparing to use your phone
The pack contains:
one Gigaset C 1 handset,
N
one charging shell,
N
two batteries,
N
one power supply unit with power cord,
N
one set of operating instructions.
N

Preparing to use the handset

The display is protected by a plastic film. Remove the protective plastic film!

Inserting the batteries

Insert the batteries ensuring correct polarity – see figure on left.
N
Position the battery cover so that it is open by around 3 mm, then slide up until it
N
closes with a click,
To open the battery cover, press on the chequered area and slide down.
N
Use only the rechargeable batteries recommended by Siemens on
page 18! Never use conventional batteries (non-rechargeable) or other
W
battery types as this may cause significant damage to health and prop-
erty. For example, the jacket of the battery could be destroyed (hazard-
ous). The phone could also malfunction or be damaged.
Placing the handset into the base (registering) and charging the batteries
When you place the C 1 handset into the C 100/C 150, C 200/C 250 or S 100/S 150 base,
it will register to the base automatically. Proceed step by step as follows:
1. Place the handset in the base with the display up.
2. Wait till the handset has registered automatically to the base: This operation takes
around one minute. While registration is in progress the screen displays
Registering and Base 1 flashes. The allocated internal number appears in the top
left of the display after registration.
3. Now leave the handset in the charger for the batteries to charge - the batteries are
supplied uncharged. Battery charging is indicated in the top right of the display by
the flashing battery icon
6
=
.