MTD ALPHA95-165H Manual De Instrucciones página 17

Operation
Setting the motor speed Q
You can set the motor speed with infinite variability
using the throttle.
Fast motor speed =
Slow motor speed =
Starting the motor
Note
The choke M is used for starting the device
when the motor is cold. Some models do
not have a choke. The motor prepares itself
automatically for the relevant start process.
Open the fuel tap (if present, see motor manual).
Î
Sit yourself down on the driver's seat.
Î
Switch off the cutting mechanism.
Î
Engage the parking brake.
Î
Set the throttle to
Î
If the motor is cold, pull the choke / set the
Î
throttle to .
Actuate the ignition key H (depending on the igni-
Î
tion lock):
Insert the ignition key into the ignition lock [3].
Î
Turn the ignition key to
Î
running. Release the ignition key.
The ignition key stays in the normal position.
Î
(Mowing in a forward direction) a .
or
Insert the ignition key [3] in the ignition lock
Î
and press it downwards for at least 1.5 seconds
until the motor starts running.
Release the ignition key.
Î
3 The ignition key stays in the normal position.
(Mowing in a forward direction) b .
Note
A start attempt should last a max. of 5
seconds. Wait 10 seconds until the next
attempt.
Note
The OCR function must not be activated
during the start process (see section "OCR
function).
Reset the choke or the throttle until the motor runs
Î
smoothly.
.
until the motor starts
Stopping the motor
Set the throttle to the mid-throttle point.
Î
Let the motor run for approx. 20 seconds.
Î
Set the ignition key (model-dependent) to
Î
or press the ignition key downwards and release it
Hb .
Remove the ignition key.
Î
Driving
Risk of sudden start-up, sudden stopping
and driving with excessive speed
ÂRisk of accident
¾ Start up slowly and brake slowly.
¾ Do not drive at excessive speed.
¾ Never change the driving direction
without first bringing the device to a stop.
Release the parking brake by stepping down fully
Î
on the brake pedal and then releasing it again.
To drive away, step on the accelerator pedal.
Î
Note
The further down on the accelerator pedal
you step, the faster the device will move.
Driving with cruise control N
Press the switch while driving.
Î
3 The forward speed selected at that point in time
(but not the maximum speed) is maintained.
3 You can take your foot off the accelerator pedal.
To deactivate cruise control, step on the brake
Î
pedal / accelerator pedal until the switch is re-
leased again.
Stopping the device A
Take your foot off the accelerator pedal C or D.
Î
Step on the brake pedal Q until the device comes
Î
to a standstill.
Note
When you step on the brake pedal, you
simultaneously switch the cruise control off.
WARNING !
EN
Ha
17