Operation; Control Panel - Davey ProMatic Manual De Instalación Y De Mantenimiento

5. OPERATION

The System Control varies the amount of time the Cell operates during the filtration cycle. The System Control will not
vary the electrical current supplied to the Cell.
As an example, if one filtration cycle is set at 5 hours, and the System Control is set to Approx. 80%, then the total
amount of time the Cell will operate during the 5-hour cycle will be 4 hours (80% of 5 hours).
When the System Control is set to MIN, the Cell will be OFF for the duration of the filtration cycle. When the System
Control is set to MAX, the Cell will be ON for the duration of the filtration cycle.
The digital production display will hover around 100 (100% = full production), except in "SPRING MODE", in which
case it will hover around 85. (see "SPRING MODE").
The unit includes an electronic regulator which limits production to a preset maximum value. The two small indicator
lights (LED 1 and LED 2) warn the user in the event of a fault, or if salinity is too low or the water too cold (below 20ºC),
unless it is in "SPRING MODE".

5.1 Control Panel

Fuse
When the right salinity has been obtained (minimum 3 g/L ), you can switch the unit on (switch in Position 1).
The small luminous "Standby" dot will light up for about 30 seconds, which is long enough for the pump to be
primed and get water flowing in the cell. When the 30 seconds are up, the production display will read approximately
100, unless the unit is in SPRING MODE (it will give a reading of about 85).
The luminous Standby dot will also light up during the cycle when the production of chlorine is interrupted, during
which time the production display will be off.
The LED 1 and LED 2 indicator lights should be green. If one or both of them is/are red, there is a problem
(see next page).
Operation LED's 1&2
AWAITING
ATTENTE
ESPERA
ATTESA
FLOW PRODUCTION %
DEBIT
CAUDAL
PORTATA
3A
FUSE
FUSIBLE
ProMatic
FUSIBILE
P/N 15643
Spring Mode Switch
SPRING MODE
POSITION
PRINTEMPS
POSICIÓN
PRIMAVERA
POSIZIONE
PRIMAVERA
1
OPERATION
2
MIN
PRODUCTION
REGLAGE
REGULACIÓN
REGOLAZIONE
®
System Control
MAX
ON/OFF Switch
11