Troubleshooting - Zanussi ZOP38903 Manual De Instrucciones

The back lamp

Troubleshooting

WARNING!
Refer to Safety chapters.
What to do if...
Problem
The oven does not heat up.
The oven does not heat up.
The oven does not heat up.
The oven does not heat up.
The oven does not heat up.
The oven does not heat up.
The lamp does not operate.
The oven does not heat up. The
fan does not operate. The display
shows or .
The display shows an error code
that is not in this table.
It takes too long to cook the
dishes or they cook too quickly.
www.zanussi.com
1. Turn the lamp glass cover counterclockwise
2. Clean the glass cover.
3. Replace the lamp with a suitable 300 °C
4. Install the glass cover.
Possible cause
The oven is deactivated.
The clock is not set.
The necessary settings are not
set.
The automatic switch-off is acti-
vated.
The Child Lock is on.
The fuse is released.
The lamp is defective.
The demo mode is activated.
There is an electrical fault.
The temperature is too low or too
high.
to remove it.
heat-resistant lamp.
Activate the oven.
Set the clock.
Make sure that the settings are
correct.
Refer to "Automatic switch-off".
Refer to "Using the Child Lock".
Make sure that the fuse is the
cause of the malfunction. If the
fuse releases again and again,
contact a qualified electrician.
Replace the lamp.
1. Deactivate the oven.
2. Press and hold
proximately two seconds. An
acoustic signal sounds.
3. Press and hold
the same time until the
acoustic signal sounds again
and the indicator goes out.
• Deactivate the oven with the
house fuse or the safety
switch in the fuse box and ac-
tivate it again.
• If the display shows the error
code again, contact the Cus-
tomer Care Department.
Adjust the temperature if neces-
sary. Follow the advice in the
user manual.
Remedy
for ap-
and at
21