Evolution EVOMAG 28 Instrucciones Originales página 26

FIG. 14
FIG. 15
A
B
FIG. 16
FIG. 17
Note: The arbor of EVOMAG28 is machined to perfectly match
the main drive spindle of the machine. Both parts are numbered
with a unique code.
main drive spindle.
removing the four (4) x M5 socket headed bolts. (Fig. 14)
Safely store the arbor, arbor support bracket and all fittings for
future reinstallation.
EVOMAG50
A three (3) jaw chuck (part HTA51) and adaptor (part HTA45)
can be fitted into the main drive spindle of this machine. This
enables EVOMAG50 to take standard twist drills up to Ø5/8in.
WARNING: Ensure that the machine is disconnected from the
mains power supply when installing a 3 jaw chuck.
(Fig. 16A) are machined onto the main drive
spindle where it emerges from the machines gearbox.
spindle from rotating.
top of the machines arbor (Fig. 16B) to unscrew the arbor from
the main drive spindle.
withdrawn from the machine, passing through the bearing in
the arbor bracket.
screws. (Fig. 17)
Store the arbor, arbor support bracket and all fittings for future
reinstallation.
EVOMAG75
WARNING: Ensure that the machine is disconnected from the
mains power supply when installing or removing the machine's
arbor or any installed accessories.
Note: EVOMAG75 is fitted with an arbor which has a No.3 Morse
Taper shank.
26
www.evolutionpowertools.com
(Fig. 15)