Sound Adjustments; Adjusting The Sound - JVC KD-LH1150 Manual De Instrucciones

SOUND ADJUSTMENTS

Adjusting the sound

You can adjust the sound characteristics to your
preference.
• "Vol Adj" setting is required for each source
except FM. Before starting "Vol Adj," select an
appropriate source for which you want to make
an adjustment.
1
Select the item you want to adjust.
Fad (Fader)
Bal (Balance)
Canceled
Only for KD-LH1150
Canceled
Indication
1
Fad* Adjust the front
and rear speaker
balance.
Bal Adjust the left
and right speaker
balance.
2
Sub Out* Adjust the
subwoofer output
level and cutoff
frequency level.
Vol Adj* 3 Adjust and store
the input level
of each source.
20
The next-step-operation
buttons start flashing.
Each time you press SEL
(select), the adjustable items
change as follows:
Sub Out
(Subwoofer Output)
only for KD-LH1150
Vol Adj
(Volume Adjustment)
To do: Range
R06 (Rear only)
|
F06 (Front only)
L06 (Left only)
|
R06 (Right only)
00 (min.)
|
12 (max.)
Low/Mid/High
–12 (min.)
|
+12 (max.)
* 1
If you are using a two-speaker system, set the fader
level to "00."
* 2
Only for KD-LH1150:
This takes effect only when a subwoofer is
connected.
* 3
By adjusting the input level to match it to the FM
sound level, you will not need to adjust the volume
level each time you change the source. This
adjustment is memorized for each source except
FM.
2
Make adjustments.
• To adjust fader and balance—Fad, Bal:
You can make these two adjustments at
the same time, by referring to the
indication on the display.
• Press 5 (up) or ∞ (down)
• Press ¢
• To adjust subwoofer output—Sub Out:
(only for KD-LH1150)
You can also set an appropriate cutoff
frequency level according to the subwoofer
connected.
• Press ¢ or 4
"Mid," or "High."
Low: Frequencies higher than 50 Hz are
cut off to the subwoofer.
Mid: Frequencies higher than 80 Hz are
cut off to the subwoofer.
High: Frequencies higher than 115 Hz
are cut off to the subwoofer.
to adjust the fader.
or 4
to adjust the balance.
To increase the level
To decrease the level
to select "Low,"