Cleaning The Filter; Clearing Blockages - Shark SV1106 N Guia Del Usuario

CLEANING THE FILTER

Your vacuum has a high efficiency dust cup to maintain strong
suction by preventing debris from collecting on the filter. To
maintain strong suction, it is important to clean the foam filter
every month, under normal use.
1 Turn off the vacuum and remove the dust cup.
2 Remove the foam filter (a) and rinse under water until the
water runs clear. (b) Squeeze the excess water out of the
filter and let it air dry for 24 hours before replacing.
DO NOT use a hair dryer or other forced hot air to dry the
filter.
DO NOT operate the vacuum without the filter in place.
DO NOT operate the vacuum with a wet filter.
NOTE: It is normal for your foam filter to discolor over time; it will
not affect the filter performance.
21 1-800-798-7398
a
b
CLEANING THE MOTORIZED FLOOR NOZZLE AND

CLEARING BLOCKAGES

An accumulation of hair, string, and other debris may sometimes
become lodged in the flexible air hose of the motorized floor
nozzle, in the air inlet of the dustcup or wrapped around the brush
roll. These areas must be free from debris for maximum cleaning
performance. To clear blockages and clean the brush roll:
1 Ensure the vacuum is off.
2 Press the release button located on the rear of the main body
3 To clear the air hose, flip back the connector to straighten
...continued on page 23.
c
d
and remove the motorized floor nozzle. (c)
the air passage (d) and carefully remove any debris lodged
in the air hose. DO NOT USE SCISSORS OR OTHER SHARP
OBJECTS AS THESE MAY DAMAGE THE HOSE.