Baby auto G-CAT 123 Manual De Uso página 28

2. Follow the steps in section 3.1(to prepare the ISOFIX.)
3. Follow the steps in section 3.2 (to adjust headrest.)
4. Take the Top Tether and lay it over the child seat.
5. Place the child seat facing in the direction of travel on the vehicle
seat.
6. Grasp the child seat with both hands and slide the two locking arms
firmly into the insert guides
(M)
a clicking noise on both sides, the ISOFIX indicator
both side (figs.8 and 9).
CAUTION! The locking arms are only correctly engaged if both of the
safety buttons
7. Push the child seat towards the backrest applying firm, even pressure
on both sides (fig.10).
8. Try to move the child safety seat to makesure it is safely attached and
recheck the green safety buttons
are completely green.
9. Take the top tether and if required, lengthen the belt by pressing
the top tether brake button to release the strap, pulling to adjust as
necessary (fig.11).
10. Hook the snap hook into the Top Tether anchoring point recommended
in your vehicle owner's guide (fig.12).
TIP: Look for this symbol in your vehicle.
11. To tension the top tether, remove any slack by pulling on the free end
of strap until it is suitably tightened. The top tether will be properly
tightened when the tension indicator turns completelygreen (fig.13).
12. Follow the steps in the next section securing your child with 5-point
harness.
4.1.1. Securing your child with 5-point harness. Group 1
The more snugly the harness fits over your child's body, the better your
child will be protected. Therefore avoid putting thick clothes on your
child under the belt.
1. Open the harness buckle
2. Press the adjusting button
belts forwards Do not pull on the shoulder pads
(D)
28
are completely green.
(R)
(E)
until the locking arms engage with
(R)
to make sure that both of them
(R)
by pressing red button.
and at the same time pull both shoulder
(F)
turn green on
(R)
(fig.14) .
(C)