Baby auto G-CAT 123 Manual De Uso página 31

4.4 GROUP 2 (15-25 kg) & GROUP 3 (22-36 kg) Vehicle belt
1. Make sure that the child seats 5-point harness is removed correctly
(see section 6).
2. Follow the steps in section 3.3 (to adjust headrest).
3. Install car seat on vehicle.
• Option A, Install child seat with ISOFIX connectors and Top tether.
1. Take the Top Tether and lay it over the child seat.
2. Place the child seat facing in the direction of travel on the vehicle
seat.
3. Grasp the child seat with both hands and slide the two locking arms
firmly into the insert guides
(M)
a clicking noise on both sides, the ISOFIX indicator
both sides (fig.8,9).
4. Take the top tether and if required, lengthen the belt by pressing
the top tether brake button to release the strap, pulling to adjust as
necessary (fig.11).
5. Hook the snap hook into the Top Tether anchoring point recommended
in your vehicle owner's guide. Look for this symbol in your vehicle
(fig.12).
6. To tension the top tether, remove any slack by pulling on the free end
of strap until it is suitably tightened. The top tether will be properly
tightened when the tension indicator turns completely green (fig.13).
• Option B, Install Child seat with ISOFIX connectors only.
1. Place the child seat facing in the direction of travel on the vehicle
seat.
2. Grasp the child seat with both hands and slide the two locking arms
firmly into the insert guides
(M)
a clicking noise on both sides, the ISOFIX indicator
onboth sides (fig.8,9).
• Option C, Install without ISOFIX connectors neither Top tether.
1. Make sure ISOFIX connectors are in shortest position.
2. Have your child sit down in the child seat.
until the locking armsengage with
(P)
until the locking arms engage with
(P)
turn green on
(R)
turn green
(R)
31