Baby auto G-CAT 123 Manual De Uso página 34

7. REFITTING THE 5-POINT HARNESS
1. Squeeze the adjustment handle
push the headrest into the lowest position (fig.41).
2. Open the left and right buttons on the lower part of the cover and lay
the cover piece on the seating area (fig.42).
3. Take the shoulder belts
compartment and unroll the shoulder belts (fig.43).
4. Fold back the two cover pieces and close the left and right poppers
on the lower part of the cover (fig.44).
5. Refitting harness buckle
belt slot closest to the backrest a ,for Group 2 (15-25 kg) use the one
furthest away.
6. Take the harness buckle
with the narrow side upwards through the belt slot a or b into the seat
shell from above (fig.45).
7. Ensure by looking underneath the seat that the metal plate is in a
horizontal position and check the installation by pulling on the
harness buckle
8. Guide the two buckle latches together and engage them before
putting them into the harness buckle
noise (fig.48).
CAUTION! The lap belts must not be twisted or swapped.
9. Thread the shoulder pads
correct orientation as shown ensuring there are no twists. Align the
two loops of the shoulder belts
pads (fig.49) .
(C)
10. Pull the shoulder belts
through the slots (fig.50).
11. Pull the strap loops of the shoulder pads
extensions of the shoulder belt height adjuster
TIP: the strap loops of the shoulder pads should be the lower loop.
CAUTION! The shoulder belts
12. Take the connecting piece from the provided storage on the back
side of the child seat.
13. Hook the shoulder belts
loop on the left arm of the connecting piece and the right loop on the
right arm (fig.52).
34
and the buckle latches from the storage
(D)
and crotch pad. Group 1 (9-18 kg) use the
(E)
and hold the metal plate verticaly. Push it
(E)
several times (fig.46,47).
(E)
(C)
and the strap loops of the shoulder pads
(D)
(D)
back onto the connecting piece. The left
(D)
at the rear of the headrest
(I)
- this should make a click
(E)
onto the shoulder belts 08 in the
and strap loops of the shoulder
(D)
must not be twisted or swapped.
(A)
onto the plastic
(C)
(fig.51).
(J)
and
(C)