Waeco MagicSafe MS670 Instrucciones De Montaje Y De Uso página 46

_MS-670.book Seite 46 Donnerstag, 8. Mai 2008 4:55 16
Programming MagicSafe
✓ After a pause of 4 s the LED begins to flash.
➤ Count the number of flashes until the number agrees with the first number
of your vehicle code:
One flash: Number 1, two flashes: Number 2, ..., nine flashes:
Number 9, ten flashes: Number 0.
➤ Press the button again.
✓ After a pause of 4 s the LED begins to flash.
➤ Repeat the steps described above for all the digits of the vehicle code.
✓ After programming, the LED flashes the vehicle code.
➤ Test the alarm system by activating it with your remote control.
✓ When you correctly enter the vehicle code, the alarm system will be
activated.
If the alarm system is not activated, you have not entered the vehicle code
correctly. Repeat the programming.
8.2 Programming
You can program the functions listed in the following table. These functions
remain stored even if the battery is disconnected.
To program a function, proceed as follows:
➤ Start the ignition with the alarm system switched off.
✓ The LED on the control device illuminates for two seconds.
➤ Insert the electronic key in the key holder within these two seconds.
✓ To indicate that the programming mode has been activated, the LED
flashes three times and the alarm siren produces three signals.
✓ The first function is activated.
I
Note:
Each time you call up the programming mode in this way, all the
values of the individual functions are reset to the factory settings
(see following table).
46
MagicSafe MS670