Makita DFL651F Manual De Instrucciones página 7

Function
This function works when the tool has
Auto-stop reached the preset fastening torque and
fastening normal tightening has been completed.
This helps overtightening to be avoided.
Insufficient fastening has been
Warning against
performed when the switch trigger has
insufficient
released before reaching the preset
fastening
fastening torque.
Warning for This indicates the appropriate time to
battery cartridge replace the battery cartridge when the
capacity battery power becomes low.
Checking the
This function works when the battery
remaining
power is almost used up. At this time,
battery capacity,
tool stops immediately.
Autostop
Check the LED This function works to check the proper
indicator, light operation of the LED indicator, light and
and beeper beeper when a battery cartridge has
operation been inserted into the tool.
This function works when an abnormal
Anti-reset of
drop of the battery voltage occurs for
controller
some reason, and the tool stops.
This function works when the
Overheat temperature of the controller goes up
very highly, and the tool stops.
This function works to avoid the tool's
Operation error
immediate start upon insertion of battery
of the switch
cartridge into the tool with the switch
trigger
trigger being pulled.
Motor failure has been detected. At this
Motor failure
time, tool does not work.
Double-hitting This function works when a screw is
detection refastened after fastening.
This function shows the maintenance
Maintenance
time has come according to your preset
alarm
number of screws driven.
Status
Status of the LED indicator/
beeper
LED indicator Beeper
Lights up in green
for approximately
one second.
Lights up in red. A long beep
Flickers in red A series of
slowly. long beeps
Lights up in red. A long beep
Lights up first in
A series of
green, next red.
very short
(And then the light
beeps
comes on.)
Flickers in red
A series of
and green
short beeps
alternatively.
Flickers in red A series of
quickly. short beeps
Flickers in red
A series of
and green
short beeps
alternatively.
Flickers in red
A series of
and green
short beeps
alternatively.
Lights up in red. A long beep
Flickers in yellow.
Action to be
taken
- -
Retighten the
screw.
Replace the
battery with fully
charged one.
Replace the
battery with fully
charged one.
-
Replace the
battery with fully
charged one.
Remove the
battery cartridge
immediately and
cool the tool
down.
Release the
switch trigger.
Ask your local
Makita Service
Center for repair.
-
Reset the
alarm with the
-
application
software.
7