ICON Stryker Back Armor Manual De Instrucciones página 2

NOT TO BE REMOVED EXCEPT BY CONSUMER
ICON
STRYKER BACK ARMOR
Motorcyclist's Back Protector
PERSONAL PROTECTIVE EQUIPMENT USER MANUAL
STANDARD EN 1621-2:2014
DIRECTIVE 89/686/EEC
CATEGORY II
®
STRYKER BACK ARMOR IN STRYKER VEST
Figure 1
FRONT PANEL
KEY:
STRYKER BACK ARMOR "SEW-IN" VERSION IN STRYKER VEST
A. REAR PLASTIC PLATES (5, 6, OR 7 DEPENDING ON VERSION)
B. FRONT PLASTIC PLATE
C. V-SHAPED HOOK AND LOOP FASTENER TAB
D. HOOK AND LOOP FASTENER MATERIAL
PPE:
The Icon® Stryker Back Armor back protector is considered Personal Protective Equipment (PPE), as defined by European Directive 89/686/EEC. The
impact protector described in this manual is considered Category II PPE and, as such, may only display the CE Mark after having undergone an EC
Type Approval and subsequent, relevant, Certification at a Notified European Body. Placement of the CE Mark on the Stryker Back Armor indicates
conformity of the back protector with the Basic Health and Safety Requirements of Directive 89/686/EEC.
The protector described in this manual, has undergone EC Type Examination at Ricotest s.r.l, Notified Body number 0498, to assure compliance
with Directive 89/686/EEC. It has additionally been examined and tested to assure its compliance with technical Standard: EN 1621-2:2014
"Motorcyclists' protective clothing against mechanical impact Part 2: Motorcyclists' back protectors — Requirements and test methods".
BACK PANEL
01