Kenmore 587.14349 Manual De Instrucciones página 11

Connecting and Disconnecting the Portable/Conve ibie
Dishwasher
The portable!convertible dishwasher must be connected to a faucet and electrical outlet each time it is used.
Follow directions on this page to properly connect dishwasher,
IMPORTANT: Make sure door is latched before movkig dishwasher.
Faucet Adapter Assembly
Connecting the Portable
Faucet Adapter Assembly
(Figure B)
Avoid fire
hazard or electrical shock Do
not use an adapter plug,
extension cord or remove
grounding prong from
electrical power cord, Failure
to follow this warning can
cause serious injury, fire or
death,
walt
Power supply
cord with 3-prong
grounding plug
The power cord, faucet coupler and hoses are located in a compartment in
back of dishwasher. A special adapter must be installed on faucet before you
cgn connect dishwasher (Figure A).
1. Remove faucet adapter assembly from literature packag_
2, Unscrew existing sink faucet aerator
5 Check faucet spout to see if threads are inside or outside,
• If threads are on inside of faucet spout, use both thick and thin rubber
washers_
• If threads are on outside of faucet spout, use thin rubber washer only.
• If faucet has no threads, an adapter kit with instructions for
attachment to a non-threaded spout is available at most hardware stores.
4. Assemble faucet spout as shown in Figure A. Make sure the two brass
screens are located below the rubber washers_
Connecting the Portable/Convertible Dishwasher
1_ Run water at faucet until it is hot, Turn off faucet.
2. Pull hoses out of compartment.
3. Push collar down and slip faucet connector onto faucet adapter (Figure B),
4 When connector snaps into place, release collar,
5 Slowty mrn on hot water all the way,
6. Plug power cord into grounded outlet.
Disconnecting the Portable/C0nvertible Dishwasher
1, When cycle has finished, turn off hot water_
2; Press red button on coupler to release water pressure.
3, Press down on collar to release coupler,
4 Empty remaining water from coupler: and return it to compm-nmenL
5, Unplug power cord and return it to comparzment,
IMPORTANT: A sink spray hose can burst due to constant water
pressure while in use. lfyour spray hose is installed on same water line
as the dishwasher, it is your responsibility to disconnect sink's spray
hose and to plug hole.
Electrica! Connection for a Portable/Convertible Dishwasher
An electrical supply of 120 volts, 60 Hz, AC only, 15 amps is required. For your
safety, the dishwasher must be grounded. If there is a maKunction or
breakdown, grounding will reduce risk of electrical shock. This dishwasher'
has a power cord with a 3-prong grounding plug. It must be plugged into a
mating 3-prong grounding tTpe receptacle, installed and grounded in
accordance with the National Electrical Code and any local codes and
ordinances.
To Convert a Portable Model to a Built-in
Your portable dishwasher can be installed under the counter. A conversion kit
is required and is available at your Sears Service Center - Pare No. 5303943139.
_i_!pl.,!;tfl!_lo Do not use the portable water supply hose for permanent I
installation It may burst Complete instructions are in the conversion kit°
I
ll