Connection - Denon DCD-485 Instrucciones De Operación

!6
Dimmer Button (DISPLAY)
• Push this button to change the brightness of the display.
• Push once to make the display 2/3 as bright as normal.
• Push again to make the display 1/3 as bright as normal.
• Push once again to turn the entire display off during playback
and all except the track number off in any other mode.
!7
2
Stop Button ( STOP)
• Push this button to stop playback or pause mode.
The disc will stop rotating.
!8
Random Button (RANDOM)
• Push this button to play the track in random order.
(Refer to page 11.)
!9
1
Play Button ( PLAY)
• Push this button to start playback of a disc during stop or
pause mode.
• When this button is pushed,
track number being played is displayed.
• Tracks are shown on the calendar display. Once a track has
been played, the corresponding track number goes out on
the calendar display.
@0
3
Pause Button ( PAUSE)
• Push this button to stop playback temporarily during
playback.
• When this button is pushed during playback, playback is
stopped temporarily, the
3
indicator lights.
PAUSE
• Push this button or the
playback.
@1
5
Open/Close Button (
• The disc holder is opened and closed by pushing this button.
• Push this button once to open the disc holder and once again
to close it.
• When the disc holder is closed with a disc loaded, the disc
will rotate for a few seconds while the disc contents are
read. The number of tracks and total playback time on the
disc are then displayed on the digital display
@2
Disc Holder
• Place the disc on the disc holder with the label facing up.
5
• Use the OPEN/CLOSE button
disc holder.
• The disc holder may also be closed by pressing the
!9
3
button or PAUSE button
@3
Digital Output Jack (OPTICAL)
• Digital data is output in optical form from this jack.
(Refer to page 7 for connections.)
@4
Output Terminal (LINE OUT)
• Connect these jacks to the input jacks on your amplifier.
(Refer to page 7 for details on the connections.)
@5
AC INLET
• Connect the included AC cord here.
1
is displayed and the
PLAY
1
indicator goes out and the
PLAY
1
PLAY button again to continue
OPEN/CLOSE)
t
.
@1
to open and close the
1
PLAY
@0 .

CONNECTION

(1) Connecting the Output Terminal (LINE OUT)
Use the included pin cords to connect the left (L) and right (R)
output terminal (LINE OUT) of the DCD-485/685 to the CD, AUX
or TAPE PLAY left (L) and right (R) input jacks of the amplifier.
DCD-485/685
D GITAL OUT L NE OUT
OPTICAL
R
Amplifier
Connection Precautions
• Before proceeding with connections or disconnections of cables
and power cords, be sure to turn all system components off.
• Ensure that all cables are connected properly to the L (left) and R
(right) jacks.
• Insert plugs fully into the terminals.
• Connect the output jacks to the amplifier CD, AUX or TAPE PLAY
input jacks.
(2) Connecting the Digital Output Jack (OPTICAL)
Use an optical link cable to connect the digital output jack
(OPTICAL) of the DCD-485/685 to the digital input jack (OPTICAL)
on a digital processor or CD recorder, available in stores.
DCD-485/685
D GITAL OUT
OPTICAL
Digital processor or CD recorder
L AC IN
Power supply outlet
L NE OUT
AC IN
R L
Power supply outlet
ENGLISH
7