Troubleshooting; Corrective Action; Maintenance - AND 767F PRO Manual De Instrucciones

Troubleshooting

Problem
Nothing appears on the
display, even when the
power is turned on.
The cuff does not
inflate.
The device does not
measure. Readings are
too high or too low.
Other
Note: If the actions described above do not solve the problem, contact the dealer. Do not attempt to open or repair this product, as any attempt to
do so will make your warranty invalid.

Maintenance

Do not open the device. It uses delicate electrical components and an intricate air unit that could be damaged. If
you cannot fix the problem using the troubleshooting instructions, contact the authorized dealer in your area or our
customer service department. The A&D customer service will provide technical information, spare parts and units to
authorized dealer.
Probable cause
Battery is drained.
Battery terminals are not in the correct
position.
Battery voltage is too low.
(LOW BATTERY mark) blinks. If
the batteries are drained completely,
the mark does not appear.
The cuff is not applied properly.
Readings are too high or too low.
The cuff position is not correct.
______________
The value is different from that
measured at a clinic or doctor's office.
______________

Corrective action

Replace all batteries with new ones.
Reinstall the batteries with negative and
positive terminals matching those indicated
on the battery compartment.
Replace all batteries with new ones.
Apply the cuff correctly.
Make sure you remain very still and quiet
during measurement.
Sit comfortably and still. Place your arm on
a table with your palm facing upward and
the cuff at the same level as your heart.
If you have a very weak or irregular heat
beat, the device may have difficulty in
determining your blood pressure.
Refer to "Why Measure Blood Pressure at
Home?".
Remove the batteries. Place them back
properly and take another measurement.
E-17