Alpine ALS 4.0 Manual De Instrucciones página 33

Step 7 – Move A1 to 90° using the "Move A1" button on
the Manual Control Screen.
Figure 79
Step 8 – Start blade using "Saw Motor On" button on
the Manual Control Screen.
Figure 80
Step 9 – Jog Z1 down using the "Jog Z1 Down" button
on the Manual Control Screen until it cuts 3/8" into the
board.
Figure 81
Step 10 – Move Z1 back to "0.0" using the "Move Z1"
button on the Manual Control Screen.
Figure 82
Step 11 – Move A1 to 270° using the "Move A1" button
on the Manual Control Screen.
Figure 83
Step 12 – Jog Z1 down using the "Jog Z1 Down" button
the Manual Control Screen until it cuts about 1/4" into
the board.
Figure 84
Step 13 – Move Z1 back to "0.0" using the "Move Z1"
button on the Manual Control Screen.
Figure 85
Step 14 – Stop the blade using the "Saw Motor Off"
button on the Manual Control Screen.
Step 15 – Release the L1 & L2 Clamps using the "L1
Clamp Up" and "L2 Clamp Up" buttons on the Manual
Control Screen.
Step 16 – Release the L1 & L2 Pushers using the "L1
Pusher Out" and "L2 Pusher Out" buttons on the Manual
Control Screen.
Step 17 – Remove the board from the saw. If the cut
measures exactly 15/32" and the shallower cut is on the
left as shown below, it is correct and the calibration of
the Center of Rotation is complete – skip to the next
section. If not, continue to Step 18.
Shallower cut
Direction of Feed
A1 should rotate about a vertical line down the center
of the back side (motor side) of the blade. The rotation
axis is built into the machine. Adjusting the Center of
Rotation will align the blade with that axis.
!
If the cut on the right of Figure 89 is the shallower cut on the left,
Contact Alpine Equipment Customer Service for assistance.
33
ALS 4.0
P R O D U C T M A N UA L
Figure 86
Figure 87
Figure 88
15/32"
Figure 89
WARNING
EN