Alpine ALS 4.0 Manual De Instrucciones página 37

Step 4 – To calibrate L1/L2, select "Controller" from the
task bar at the bottom of the screen (Figure 109).
Figure 108
The screen in Figure 109 will appear:
Figure 109
Step 5 – Select the "Calibrate L1 & L2 & L1P Lengths"
button (circled on Figure 109 and shown in Figure 110).
Figure 110
Step 6 – Enter the commanded distance (the length
input) and the actual measured distance using the box
shown in Figure 111.
Step 7 – Select "Execute L1 Calibration". This button is
shown in Figure 111 and Figure 112.
The following message (Figure 113) should appear.
Step 8 – Repeat for axis L2.
Step 9 – Select "Exit".
37
EN
ALS 4.0
P R O D U C T M A N UA L
Figure 111
Figure 112
Figure 113