Stove Work Phase; Stove Switch-Off; Modification Of Ambient Temperature Setting - klover DEA ECO8 Instalación Uso Y Mantenimiento

Stove work phase

During the work phase, by pressing button 1 first then buttons 1 or 2, it is possible to set a "SET
TEMPERATURE" value (general temperature of the room where the stove is installed); when this
temperature is reached, the stove enters the economy mode in which fuel consumption is reduced to a
minimum.
There are several work conditions available, which are listed below:
▪ If the "M4 – STAND-BY" menu is set to "OFF", when the temperature set with the "SET TEMPERATURE"
function is reached, the stove enters the "MODULATE" economy mode without however switching off.
▪ If the "M4 – STAND-BY" menu is set to "ON", when the temperature set with the "SET TEMPERATURE"
function is reached, the stove enters the "GO STBY" mode in which a countdown (Pr44) starts for
automatically switching off the stove. The device then enters the "STOP ECO TEMP GOOD" stand-by
mode and will automatically restart once the proper conditions occur again (Pr43 = SET TEMPERATURE
– 2.5°C). If restarting occurs while the stove is still performing the switch-off cycle, it is advisable to wait
for the latter to finish.
At pre-defined intervals, a brazier cleaning cycle is performed (indicated on the display by "BRAZIER
CLEANING") for a pre-defined duration (see parameters table).
ATTENTION:
- If you do not wish to control the stove with an ambient temperature, it is advisable to set the "SET
TEMPERATURE" value to "MAN" (Manual).
- If the stove is connected to an external ambient thermostat, the latter will only modulate and/or switch off
if - provided that the other conditions occur - the temperatureIset on the external ambient thermostat has
been reached (ambient thermostat contact open).

Stove switch-off

Pressing button 3 (ON/OFF) switches the stove off. The display shows "FINAL CLEANING". The flow of
pellets is interrupted switching the gearmotor off. The flue gas extractor speed is increased to maximum, and
the extractor is switched off stove cools: the word "OFF" will appear on the display.

Modification of ambient temperature setting.

To modify the ambient temperature, simply select the "SET TEMPERATURE" mode by pressing button 1.
Press buttons 1 and 2 for increasing or decreasing - respectively - the desired temperature. During this
operation, the display will appear as in the picture below.
After setting the desired value, press button 3 or wait a few seconds.
The stove will enter the economy mode upon reaching said temperature.
Moreover, it is possible to set the stove to manual operation ("MAN"). In this way, the stove will continue
operating at the pre-set working power, regardless of the ambient temperature.
25.0
27