Stanley Bostitch GF28WW Instrucciones De Seguridad Y Empleo página 14

CHECKING MOUNTING SCREWS
At regular intervals, check every part for loose mounting
screws and tighten any loose screws found. Operating
the tool with loose screws will can be hazardous.
INSPECTING THE CONTACT ARM
Check if the contact arm can slide smoothly.
Clean the sliding area of the contact arm and use the
provided oil for lubrication from time to time.
This will enable a smooth operation and simultaneously
help to prevent the formation of rust.
PREPARATION FOR STORAGE
● When not in use for an extended period, apply a thin
coat of the lubricant to the steel parts to avoid rust.
● Do not store the nailer in a cold weather
environment. When not in use, the tool should be
stored in a warm and dry place.
● Keep out of reach of children.
● Refer to all instructions in the previous 'Storage'
section of this manual.
SERVICE PARTS LIST
CAUTION: Repair, modification and inspection of
Bostitch Power Tools must be carried out by a Bostitch
Authorised Service Center.
The Parts List supplied with this tool will be helpful if
presented with the tool to the Bostitch Authorised
Service Center when requesting repair or other
maintenance.
In the operation and maintenance of power tools, the
safety regulations and standards prescribed in each
country must be observed.
MODIFICATIONS
Stanley Bostitch tools are constantly being improved and
modified to incorporate the latest technological
advancements.
Accordingly, some parts may be changed without prior
notice.
APPLICABLE LUBRICANTS
Use BOSTITCH Gas Nailer lubricant.
Do not use detergent oil or additives: these lubricants
will harm the O-rings and other rubber parts and will
cause the tool to malfunction.
NOISE AND VIBRATION DATA
NOISE EMISSION (See Tool Technical Data)
The characteristic noise values for the tool have been
determined in accordance with EN 12549 - "Acoustics -
Noise test code for fastener driving tools - Engineering
Method."
These values are tool related characteristic values and
do not represent the noise development at the point of
use. Noise development at the point of use will depend
for example on the working environment, the work piece,
the work piece support and the number of driving
operations, etc.
Depending on the conditions at the workplace and the
form of the work piece, individual noise attenuation
measures may need to be carried out, such as placing
work pieces on sound damping supports, preventing
work piece vibration by means of clamping or covering,
adjusting to the minimum air pressure required for the
job, etc.
INFORMATION ON VIBRATION (see Tool Technical
Data)
The characteristic vibration value for the tool has been
determined in accordance with ISO/WD 8662-11
"Measurement of vibration in hand held power tools -
Part 11 Fastener Driving Tools".
This value is a tool related characteristic and does not
represent the influence on the hand-arm system when
using the tool. An influence on the hand-arm system
when using the tool will depend for example on the
gripping force, the contact force, the working direction,
the adjustment of the compressed air supply, the work
piece, the work piece support, etc.