• When the relevant memory button (M1 or
M2) is pressed again, the last individual
measurement is displayed (in this example,
measurement 03).
• When the relevant memory button (M1 or M2) is
pressed again, you can view your individual measure-
ments.
• To switch the device off again, press the Start/stop
button
.
You can exit the menu at any time by pressing the
Start/stop button
• To clear the memory of the relevant user memory, you
must first select a user memory.
• Start individual measurement access.
• Press and hold the M1/M2 memory buttons for 5 sec-
onds.
All the values in the current user memory are
deleted.
Transferring measurements
Connect the blood pressure monitor to your PC using the USB
cable.
No data transfer may be launched whilst performing a
measurement.
.
PC is shown on the display. Begin the data transfer
PC
in the "beurer HealthManager" PC software. During
the data transfer, an animation is shown on the
display. A successful data transfer is displayed as
in figure 1. If the data transfer is unsuccessful, an
error message appears as in figure 2. In this case,
interrupt the PC connection and start the data
transfer again.
After 30 seconds of not being in use or if commu-
nication with the PC is interrupted, the blood pres-
sure monitor switches itself off automatically.
8. Cleaning and maintenance
• Clean the device and cuff carefully using a slightly damp
cloth only.
• Do not use any cleaning agents or solvents.
• Under no circumstances hold the device and cuff under wa-
ter, as this can cause liquid to enter and damage the device
and cuff.
• If you store the device and cuff, do not place heavy objects
on the device and cuff. Remove the batteries. The cuff line
should not be bent sharply.
9. Accessories and replacement parts
Accessories and replacement parts are available from the cor-
responding service address (according to the service address
list). Please state the corresponding order number.
33
figure 1
figure 2