Installation Of The Appliance; Avoiding Radio Interference; Assembling The Accessories; Glass Turntable - CASO DESIGN HCMG 25 Manual De Instrucciones

13.5.2
clearance of 30 cm is needed, and on the sides at least 20 cm distance to other
walls or units are needed.
c) Do not remove the feet from the bottom of the appliance.
d) Do not cover or obstruct any openings in the appliance.
e) Covering the ventilation slots may cause damage to the appliance.
f) Place the microwave appliance as far away from radios of TVs to minimize any
interference to radio and TV reception.
2) Insert the power plug into a normal household outlet; check that voltage and
frequency of the appliance (see appliance rating label) matches that of the
household electrical supply.
13.5.3
The device can cause the occurrence of interference in radios, televisions or similar
devices.
Such faults can be rectified or reduced as a result of employing the following measures:
 Clean the door and the sealing surfaces of the device.
 Set the radio, the television, etc as far as possible away from the device.
 Connect the device to a different electrical outlet, so that various power circuits are used
for the device and the receiver with the interference.
 Use a properly installed antenna for the receiver, to ensure good reception.

13.6 Assembling the accessories

13.6.1
 1 Hub (underside)
 2 Glass turntable
 3 Turntable drive
 4 Rolling ring

Installation of the appliance

Avoiding radio interference

Glass turntable

1) Select a level surface
providing enough distance
between the ventilation
slots and walls or other
units.
a) The surface for placing
the appliance must be at
least 85 cm above the
floor.
b) The rear of the appliance
must be facing a wall.
Above the appliance a
59