Maintaining Your Vacuum; Emptying The Dust Cup; Cleaning The Filters - Shark Rocket HV320 Guia Del Propietario

MAINTAINING YOUR VACUUM

IMPORTANT: Clean the dust screen
inside the dust cup as required�
NOTE: Empty dust cup when debris
reaches the MAX fill line�
15
s h a r kc l e a n . c o m

EMPTYING THE DUST CUP

1
Press the Wand Release button on
the top of the wand to disconnect
it from the handheld vacuum�
OR
Remove the dust cup from the
handheld vacuum by squeezing the
two Dust Cup Release buttons on
both sides of the base at the same
time and pulling it out�
2 Hold dust cup over a trash bin and
press the Empty button on the front
of the dust cup� The bottom lid will
open, allowing the debris to fall out�
3 Once dust cup is empty, close the
bottom lid and insert dust cup back
into handheld vacuum until you it
clicks into place�
Empty
RECOMMENDED FILTER CLEANING
SCHEDULE:
Pre-Motor Filter Kit
(Foam & Felt)
XPMFK320
Clean once a month�
Post-Motor Filter
Clean once a year�
1084FTV320

CLEANING THE FILTERS

1 Pre-Motor (foam and felt):
Lift the latch on the top of the
handheld vacuum to open the filter
cover� Take out filters and tap loose
dirt off them� If more cleaning is
needed, rinse filters with water only
and let them air-dry completely�
To reinstall them, insert the felt
filter first, place the foam filter on
top of it, and close the filter cover�
2 Post-Motor:
Lift off the post-motor filter cover
below the handle of the handheld
vacuum� Remove the filter, rinse it
with water only, and let it air-dry
completely� Replace the filter, then
close the cover, pressing it until it
clicks into place�
Felt
s h a r kc l e a n . c o m
Foam
16