Nilox 17NXBAON12001 Manual Del Usuario página 28

Battery mode start (Cold Start)
 Hold down the UPS ON
the ON button and repeat the procedure within 10 seconds, holding down the ON button again at UPS start for
about 3 seconds. If the procedure was correctly followed, the UPS will start in Cold Start mode and the LCD
display will show the image illustrated below. The UPS is operating in Backup mode [buzzer, indicator
INPUT
UPS
 The following limits must be met in Cold Start mode:
 The load should not exceed 80% of the supported load
 The load should remain constant
Information found on the display
Values and messages can be viewed by pressing key
following is displayed in order: AC Input Voltage, AC Input Frequency, UPS Output Voltage, UPS Output Frequency,
UPS Load %, UPS Output Current, UPS Battery Voltage.
INPUT UPS LOAD
INPUT LOAD
UPS
UPS block
The UPS can block following particular events. A screen will appear on the LCD display with numeric information
on the block code.
INPUT UPS LOAD
The following procedure unlocks the device.
 Note the displayed error code (contact customer service for information on problem solving).
 Press the OFF button
 Remove the power cord.
 Wait until the UPS is fully off. The UPS is fully unlocked at this point.
button for about 3 seconds to turn on the unit. The buzzer will beep twice. Release
LOAD
Battery
V
INPUT LOAD
UPS
%
Code
and hold down for 5 seconds until the device beeps twice.
V
(when the UPS is running in Normal/Battery mode). The
INPUT LOAD
UPS
Battery
A
V
on].