Password; Change Password; Testing; Maintenance - Roger H70/200AC Instrucciones Y Advertencias Para El Instalador

P1 00
P2 00

Password

P3 00
P4 00
CP 00

Change password

By saving a password, you enable protection of stored data so that only people who know the password can
edit the data in question. To enter a password, proceed as follows:
• enter the eight numbers chosen for the password in parameters
• call up parameter
flashes, it means the new setting has been saved.
Password protection is activated immediately by switching the control unit off and back on again or after 30
minutes of no activity when the display switches to standby mode.
PLEASE NOTE! When password protection is activated, the + and - keys cannot be used to change the value
of a parameter and parameter
To unlock parameters (temporarily), proceed as follows: enter the previously saved password in parameters
p1 p2 p3 P4
, , and
(protection off).
You can delete the password only if you know it, proceeding as follows: enter the password, then save
p1 00 p2 00
password ,
If you misplace the password, you can unlock the control unit by getting in touch with our support team.
12

Testing

Check response to all controls connected.
Check travel and slow-down distances
Check impact forces.
Check behaviour in response to triggering of safety
devices. When the anti-crush device senses an
obstruction, make sure you are well away from the
limit switches or obstacles, which increase the risk
of crushing.
Check that release is working properly with the
leaves fully closed.
13

Maintenance

Perform scheduled maintenance at 6-month
intervals, checking that the unit is clean and in
proper working order.
If you find dirt, moisture, insects or anything else,
disconnect the power and clean the board and
enclosure. Repeat the test procedure.
If you notice signs of oxidation on the printed circuit,
assess whether it needs replacing.
CP
on the display: hold the + and - keys down together for 4 seconds. Once the display
CP
has the value
, then call up parameter
p3 00 p4 00
, ,
01
.
CP
on the display and make sure it has the value
, remembering to confirm the setting with parameter
14

Disposal

As with installation, the product must be uninstalled
by qualified technical personnel implementing
appropriate procedures to remove the product
correctly.
This product comprises materials of various kinds.
Some can be recycled, while others must be
disposed of through recycling or disposal systems
in line with local regulations governing this kind of
product.
Do not throw this product away with household
waste. Sort the product into like materials for
disposal according to the methods set out by
local regulations; or hand the product back in to
the dealer when you purchase a new equivalent
product.
Local regulations may impose heavy fines in the
event of illegal disposal of this product.
Warning: some parts of the product
may contain pollutant or hazardous
substances that, if released to the
environment, can have harmful effects
both on the environment and human
health.
p1 p2 p3 P4
, , and
00
CP
.
43