Line Voltage & Control Power Termination - Leviton DMX Serie Guia De Instalacion

Line Voltage & Control Power Termination
Overview of Power Wiring - Feed\Line Wiring
Wiring is simple. All you need is the following:
• Dedicated circuit for control power - Hot, Neutral and Ground
• Individual load wires leaving relays, output circuits.
NOTE: Since the panel is fed from multiple circuits, locate each one and lock-out
each feed in the OFF position.
All cabinets have ample area for conduit entries for feed, load, and control wiring.
Ensure that conduit entry is only in the allowed locations. Refer to diagrams on prior
pages for permitted locations.
Each relay panel has areas dedicated for line voltage wiring and similar orientation.
Please find on the next few pages figure which illustrate this.
6
Line Voltage & Control Power Termination
Overview of Power Wiring - Feed\Line Wiring