Service; Trouble Shooter - THERMEx TOP LINK MODUL III Instrucciones De Montaje

50 THERMEX Top Link III
SETTING OF SET POINT FOR HOB
Top Link is set as standard to start the hood at a minimum load of 200 Watt when it is controlled from the hob. Top Link does not need to be
adjusted, but is ready for use after installation via the hob's power supply.
To start at a different minimum load, it is set in the following way:
HOB
1. Turn on the hob at the minimum load selected.
2. Hold down the "Set level" button until the yellow LED "Set 1" starts to flash rapidly.
3. When the "Set 1" LED is lighting constantly, the set point is set.
4. Turn off the hob. NOTE: The yellow "Set 1" LED must turn off when the hob is turned off, otherwise the set point must be set again.
OVEN
1. Set the oven to the selected minimum load.
2. Hold down the "Set level" button until the yellow LED "Set 1" starts to flash rapidly.
3. When the "Set 1" LED is lighting constantly, the set point is set.
4. Turn off the oven. NOTE: The yellow "Set 1" LED must turn off when the oven is turned off, otherwise the set point must be reset again.

SERVICE

Before reporting service on your Thermex range hood, it is important that you read the installation and/or user instructions carefully. It ensures that
Thermex can provide you the best possible assistance.
Service department at Thermex can be contacted in preparation to:
• Technical support for installation and installation of your range hood.
• Clarification of functionalities in your hood.
• Service Request during the warranty on your hood .
Before a service request during the warranty always try to disconnect the power to the hood for about 5 min. Then plug the power back on to see if the
problem is corrected.
If the problem is not corrected, disconnect the power supply to the hood for one hour. If the hood is still not functioning properly, and the troubleshoot-
ing charts are reviewed, contact the service department.
NOTE: For inquiries within the warranty, you will be asked for proof of your purchase in the form of a sales receipt. Therefore, always store your sales
receipt
Before the request for service within the warranty, it is important to have all the necessary information ready:
• Error Description
• Model
• The type and serial number of the hood (on the chassis plate)
• Information of puchase

TROUBLE SHOOTER

PROBLEM
The hood does not start when the hob or oven
is turned on.
The hood does not turn off when the hob or
oven is turned off.
MULIG ÅRSAG
Top Link and hood is not connected.
The set point is not set correct.
The 10 seconds delay is activated.
The set point is not set correct.
M 536991350901122020
LØSNING
Follow the instructions for connecting Top
Link and hood.
Follow the instructions for setting the set
point.
Set dipswitch 3 without delay.
Follow the instructions for setting the set
point.