Software Parameters - DART Controls DP4 CONTROL Serie Manual De Instrucciones

Software Parameters

Parameter
0 Selecting this item exits to Running Mode
Read-Only Parameters
1 Model Number
2 Software Build
3 Hardware Version
4 Serial Number – Major (reserved)
5 Serial Number – Minor (reserved)
General Setup
10 Operating Mode
11 Display Intensity
12 Display Zero Blanking
13 Decimal Point Position
15 Keypad Mode
16 Keypad Scroll Delay
18 Power-up Mode
19 Power-up Value
Display & Output Setup
20 Display Value at Minimum Output
21 Display Value at Maximum Output
22 Display Value at Center Output (Bipolar Only)
25 Output % - Minimum
26 Output % - Maximum
27 Output % - Center (Bipolar Modes Only)
28 Output Deadband Width
Description
9
Value Range
(units)
n/a
40 – DP4 Unit
1 – 9999
1 – 9999
n/a
n/a
Rate Modes:
1 – Unipolar Output
2 – Unipolar Output with Deadband
3 – Bipolar Output
4 – Bipolar Output with Deadband
Time Modes:
5 – Unipolar Output
6 – Unipolar Output with Deadband
7 – Bipolar Output
8 – Bipolar Output with Deadband
Other Modes:
9 – Absolute Value Output with Relay
Direction Control
10 – Absolute Value Output with
Relay Direct. Control and Deadband
0 – 31 (Dim – Bright)
1 – ___X Show at least 1 Digit
2 – __XX Show at least 2 Digits
3 – _XXX Show at least 3 Digits
4 – XXXX Show all 4 Digits
0 – DP Disabled (XXXX)
1 – X.XXX
2 – XX.XX
3 – XXX.X
4 – XXXX.
1 – Linear, Constant Rate
2 – Non-linear, Accelerating Rate
0 – 30 (Fast – Slow)
1 – Default to Zero Display
2 – Default to Power-up Value
3 – Default to Previous Running Val.
0 – 9999 (Display Units)
-9999 – 9999 (Display Units)
-9999 – 9999 (Display Units)
-9999 – 9999 (Display Units)
0 – 1000 (1/10th Percent Units)
0 – 1000 (1/10th Percent Units)
0 – 1000 (1/10th Percent Units)
0 – 1000 (1/10th Percent Units)
Factory User
Default Settings
n/a
40
n/a
n/a
n/a
n/a
1
26
2
3
2
10
3
0
0
1000
0
0
1000
500
0