DART Controls DP4 CONTROL Serie Manual De Instrucciones página 12

Software Parameters, cont'd
Parameter
Signal Input #1 (S1) Setup
30 S1 Input Configuration
31 S1 Setpoint
Signal Input #2 (S2) Setup
35 S2 Input Configuration
36 S2 Setpoint
Alarm Output Configuration
40 Activation Conditions
41 Output Style & Reset Mode
42 Reset Configuration
43 Display Flash On Active Alarm
44 Pulse on Time
45 Pulse off Time
46 Pulse Count
47 Lower Limit
48 Upper Limit
Parameter Memory Commands
95 Restore Settings to Factory Default
98 Save to User Default Area
99 Restore from User Default Area
Description
10
Value Range
(units)
1 – Output 0% When S1 Low
2 – Output 0% When S1 High
3 – Output Setpoint When S1 Low
4 – Output Setpoint When S1 High
5 – Output 100% When S1 Low
6 – Output 100% When S1 High
-9999 – 9999 (Display Units)
1 – Output 0% When S2 Low
2 – Output 0% When S2 High
3 – Output Setpoint When S2 Low
4 – Output Setpoint When S2 High
5 – Output 100% When S2 Low
6 – Output 100% When S2 High
-9999 – 9999 (Display Units)
0 – Always Off
1 – Always On
2 – Active when Above upper limit
3 – Active when Below lower limit
4 – Active inside Range
5 – Active outside Range
6 – Active Zero or Equivalent Output
7 – Relay Direction Control Mode
1 – Constant & Auto Reset
2 – Constant & Manual Reset
3 – Pulsed & Auto Reset
4 – Pulsed & Manual Reset
1 – No Sil., Reset on Key
2 – No Sil., Reset on S2 High
3 – No Sil., Reset on S2 Low
4 – Sil., Reset on Key
5 – Sil., Reset on S2 High
6 – Sil., Reset on S2 Low
0 – Alarm Flash Disabled
1 – Alarm Flash Enabled
1 – 3600 (seconds)
1 – 3600 (seconds)
0 – 9999 (pulses)
0 – 9999 (display units)
0 – 9999 (display units)
0 – Do Nothing & Exit
5 – Restore Factory Defaults
0 – Do Nothing & Exit
5 – Save Setting
0 – Do Nothing & Exit
1 – Restore Settings
Factory User
Default Settings
1
0
1
0
0
1
1
0
1
1
0
0
9999
0
0
0