thE CLOCk Can't SYnChROnIZE ItSELF thROUGh
thE nEtwORk (StatE « COMMUtInG » OR « DEtECt FaIL »)?
1. verify that you can ping the ntP server and that the network parameters are in
►
the same range on the clock and the server.
►
nO
The clock and the server must be in the same network to communicate.
►
YES
Continue...
2. Open the NTP panel of the configuration WEB page and verify that the IP ad-
►
dresses of the ntP servers are correct.
If the state is in "auto-detect" mode, restart your device: the auto-detection is done
at start-up (restart the Ethernet interface by pressing the RESET button).
MDE-LEDInetworkTOP-4092-V1.1
79