Beta 1852 R1750 Manual De Instrucciones página 15

INSTRUCTIONS FOR USE ISTRUZIONI PER L'USO
COMPONENTS
5
6
USE
Before using the device, check the incoming cable, handle and handle cable to ensure that they are not damaged.
1. Disconnect the device from the electric network and loosen the screws on the handle.
2. Insert the working coil into the holes in the clamping holder of the coils (handle, 2), and tighten the locking screws on the sides.
3. Connect the supply cable of the device into a properly grounded standard socket ~230V, 50/60Hz, and turn on the device using
the main switch. Before turning on, make sure that the handle is laid in a safe place and that the heating button is not pressed
down.
4. Attach or put the working coil on the material you want to warm up and press the button on the handle. Heating remains
activated while the button is being pressed – do not exceed the operating cycle of 2 minutes of heating and 2 minutes of cooling.
5. After finishing the cycle, release the button on the handle, and remove the heating coil from the heated material.
NB: During heating there should be a gap of approximately 3-5 mm between the coil and the heated material to
avoid excessive wear of the heating coil. A gap larger than 3-5 mm decreases heating efficacy and extends the
heating time.
After finishing heating, place the handle with the heating coil in a safe place free from inflammable materials until
the heating coil is completely cooled. Then turn off the device using the main switch, and disconnect it from the
electric network.
CAUTION: The coil and the heated object can reach high temperatures and/or cause burns or result in fire.
1 1. PLASTIC CASE WITH PROTECTIVE LINING
2. COIL HOLDER
3. CONNECTION CORD
4. SWITCH ON AND OVERHEATING INDICATION LIGHT
5. COVER FITTED COILS
6. ELECTRIC SUPPLY CORD
2
3
4
EN I
15