Storage And Maintenance - Beta 1852 R1750 Manual De Instrucciones

INSTRUCTIONS FOR USE ISTRUZIONI PER L'USO

STORAGE AND MAINTENANCE

COOLING, DISMANTLING AND STORAGE
After completion of heating, make sure that the coil holder and coils used are placed in a safe place. Handling the device or its
parts before letting it cool down can result in injury, damage to the equipment or fire.
After completion of heating, leave the device turned on for 10 more minutes – the device will be cooled down by the fans until
cooled off completely, and then will turn off the fans. Then shut it down by the main power switch and disconnect it from the power
supply.
If you unplug the unit immediately, let all the working coils cool down for at least 15 minutes.
After cooling, place the device and its accessories in the case. Place the cords so as to avoid their sharp bending or twisting – it
could cause them to get damaged.
PROPER CLEANING AND MAINTENANCE
Make sure the device is turned off, unplugged and cooled. Use a dry, clean cloth or paper towel to remove grease, oil and other
impurities from the machine, applicators and cables before placing the device BETA 1852 in the storage case.
Use freely available non-volatile cleaning agents for grease, oil and dirt that is difficult to remove. Before the first reuse of the
induction heater BETA 1852, allow all components to air dry.
Do not immerse any part of the device in water or other liquids. Do not spray and wash the device down with water spray. Do not
clean the components with volatile organic compounds, such as petrol, benzene, kerosene, methyl ethyl ketone (MEK), fuel oil,
brake parts cleaners, paint and thinner removers, varnish removers, self-adhesive solvents etc. These substances cause fire as
well as hardening or dissolving of polymeric materials used in the device.
Do not use heat sources, heaters, burners, microwave ovens or gas ovens etc. for drying the device and its parts after cleaning.
WARRANTY
1. Machine warranty period is determined by the manufacturer for 12 months from the sale of machinery to the buyer. Warranty
period begins on the date of delivery of the machine to the purchaser, or the possible delivery date. The warranty period does not
cover expendable parts - coils. Warranty period does not include the period from the submission of a legitimate complaint until
the machine is repaired.
2. The warranty covers responsibility for the delivery of the machine at the time of delivery, and the warranty period will have such
characteristics as laid down by mandatory specifications and standards.
3. Responsibility for defects that occur after the machine under warranty is sold consists in the obligation for the machine supplier
or an authorised service organization to remove the defect for free.
4. A condition of warranty is that the machine is used in a manner and for the purposes for which it is intended. Such defects as
extraordinary wear and damage due to insufficient care or neglect in case of seemingly insignificant defects will not be recogni-
sed. The defects that cannot be recognised include the following:
a. Damage to the equipment due to inadequate maintenance.
b. Mechanical damage due to rough handling etc.
5. The warranty does not cover damage due to failure to meet the obligations of the owner, inexperience, impairment, failure to
comply with such provisions as referred to in the instructions for use and maintenance, the use of the machine for purposes for
which it is not intended, overloading of the machine, even if temporary. Maintenance and repair jobs may only be performed by
the manufacturer of the original equipment.
6. During the warranty period of the machine, the machine may not be subjected to any modifications or changes which can affect
the function of any part of the machine. Otherwise, the warranty will not be accepted.
7. Warranty claims must be submitted immediately upon detection of manufacturing defects or material defects.
8. If any defective part is replaced during the warranty period, ownership of the defective part will be transferred to the manufacturer.
18
EN I