Beta 1852 R1750 Manual De Instrucciones página 16

INSTRUCTIONS FOR USE ISTRUZIONI PER L'USO
DETACHABLE COILS
Application of the standard attachable front and side coils for heating nuts, couplings, gaskets, hinges, exhaust mains, screws etc.
which are accessible so as to allow the coil to be attached.
NB: The service life of the coils can be extended by cleaning rust, paint, oil etc. from the heated material.
During heating, there should be a gap of approximately 3-5 mm between the coil and the heated material to avoid
excessive wear of the heating coil. Holding the coil directly on the hot material may cause the coil insulation to get
burnt, thereby shortening the service life of the coils. We recommend limiting direct contact of the coil with the hot
material to the minimum.
TIP! To loosen nuts, screws etc., it is not necessary to heat the material until it is red hot. Heat the nut for 2 seconds, and try to
loosen it using a wrench. If this is not possible, heat again for 2 seconds, and then try to loosen it using the wrench again.
FLAT COIL
The flat spiral shaped coil is intended for heating flat metal sheets and straightening small dents in car bodies by heating. The flat
coil is also intended for easily peeling off stickers, sealants, putties etc. by heating the base material (steel sheet metal).
1. Connect the coil to the coil handle.
2. Place the coil with its area over the material.
3. Press the button and guide the coil above the material in a gyratory movement.
4. After heating the material, allow the coil to cool off for at least 2 minutes.
NB: The coil can be used to remove adhesive stickers, sealants and gaskets which are stuck to sheet metal or
metal – for example, in automotive, services etc. The coil is used to heat, and thus soften, the base material, or,
alternatively, to harden glue, putty etc. We recommend holding the coil approximately 5-15 mm far from the heated
material – the required temperature and heating time can be regulated by changing the distance.
16
FRONT ATTACHABLE COILS
The standard supplied diameters of front attachable coils are 19-45 mm
SIDE ATTACHABLE COILS
The standard supplied diameters of side attachable coils are 19-45 mm
EN I