Kübler CODIX 923 Manual De Instrucciones página 37

For the subtracting modes (SUB, SUBAR,
SUBBAT and SUBTOT), a „Reset" (via the
key or the input) resets the counter/the
time counter to a new preset value 2.
7.8.6.3
Mainmenu for configuration
Mainmenu for matching the time
ranges and display
Unit of time
Unit of time: seconds
Decimal point setting determines
the resolution
Unit of time: minutes
Decimal point setting determines
the resolution
Unit of time: hours
Decimal point setting determines
the resolution
Unit of time: Hrs. Min. Sec.
Decimal point setting (Resolution)
Decimal place
(determines the resolution)
0
0.0
0.00
0.000
Set value
Set value can be programmed
from 000000 to 999999
A previously programmed
decimal point will be displayed
Display colour (for 6.92x.x1x3.xx0]
Display colour
upper line
lower line
Display colour
upper line
lower line
7.8.6.4 Mainmenu for reset mode
Setting the reset mode
www.kuebler.com
no decimal place
1 decimal place
2 decimal places
3 decimal places
red
red
red
green
Manual reset (with red key) and
electrical reset (reset input)
No reset possible (red key and
reset input inhibited)
Only electrical reset possible
(reset input)
Only manual reset possible (red
key)
7.8.6.5 Mainmenu for Preset
Mainmenu for the preset
ADD mode output operations:
permanent signal at the output,
becomes active when count >
preset
SUB mode output operations:
permanent signal at the output,
becomes active when count < 0
ADD mode output operations:
permanent signal at the output,
becomes passive when count >
preset
SUB mode output operations:
permanent signal at the output,
becomes passive when count < 0
ADD mode output operations:
timed signal at the output,
becomes active when count >
preset. (Activation only in positive
direction)
SUB mode output operations:
timed signal at the output,
becomes active when count < 0.
(Activation only in negative
direction)
ADD mode output operations:
timed signal at the output,
becomes passive when count >
preset. (Deactivation only in
positive direction)
SUB mode output operations:
timed signal at the output,
becomes passive when count <
0. (Deactivation only in negative
direction).
Page 13